[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#234770: installation-reports: Success on m68k mac



Package: installation-reports
Severity: normal

INSTALL REPORT

Debian-installer-version:
    <http://marenka.net/~stephen/di/
        boot/dest-20040223-0205/mac/netboot-initrd.gz>
    <http://marenka.net/~stephen/di/
        cds/daily/dibase-m68k-20040224-0851.iso>

uname -a: Linux debian 2.2.25 #1 Thu Jan 15 09:40:15 CST 2004 m68k
GNU/Linux

Date: 1000 25 Feb. 2004
Method: 
    How did you install?   
        Used netboot ramdisk to load d-i components, then load-iso to
	install base from an iso sitting on the MacOS partition.
    What did you boot off?  native MacOS hard drive, Penguin
    If network install, from where?  private base+d-i 
    	(everything should be in the archive now)
    Proxied?  yes.

Machine: Apple Mac Centris 650
Processor: 68040/25
Memory:	136MB
Root Device: scsi /dev/sda6
Root Size/partition table:  
    /dev/sda1-3 Apple partition stuff
    /dev/sda4   300M HFS
    /dev/sda5   270M swap
    /dev/sda6   1.4G root

Output of lspci: n/a

Base System Installation Checklist:

Initial boot worked:    [O]
Configure network HW:   [O]
Config network:         [O]
Detect CD:              [O] (iso)
Load installer modules: [O]
Detect hard drives:     [O]
Partition hard drives:  [O]
Create file systems:    [O]
Mount partitions:       [O]
Install base system:    [O]
Install boot loader:    [O] (nobootloader)
Reboot:                 [O]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Comments/Problems:

My first full installation of a m68k mac running a 2.2.25 kernel.

I booted the mac into Mac OS. 

I downloaded the netboot initrd, kernel, and dibase-m68k.iso from 
<http://marenka.net/~stephen/d-i/> onto the mac's harddrive.

I booted d-i using Penguin-19 (the mac bootloader). 

I installed the remaining d-i components, including load-iso, off the
net (again marenka.net).

I partitioned and formatted the linux partitions using partitioner 
and partconf. 

I then ran load-iso to mount the iso.

I then proceeded with base-installation.

Once that was done, I rebooted into MacOS and used Penguin to do a
boot back into linux with root=/dev/sda6 and started base-config.

It's all good.

-- 
Stephen R. Marenka     If life's not fun, you're not doing it right!
<stephen@marenka.net>

Attachment: signature.asc
Description: Digital signature


Reply to: