d-i & IBM CHRP testing
This is as far as I got. I get the error message with both graphics and
RS232 console. I tested it on both p610 and 44P-170. I booted via
BOOTP/tftp and mounted the root file system via NFS.
It is also interesting that the 'rootpath' parameter is empty, see below.
Kernel is version 2.4.18 from kernel.org. I compiled in additional network
and root filesystem support.
Any ideas?
0> boot net:9.3.52.93,,9.3.52.82 root=/dev/nfs
nfsroot=9.3.52.93:/export/di/root_fs ip=9.3.52.82:9.3.52.93
~snip a whole lot
LVM version 1.0.1-rc4(ish)(03/10/2001)
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 16384 buckets, 128Kbytes
TCP: Hash tables configured (established 262144 bind 65536)
Sending DHCP and RARP requests . OK
IP-Config: Got DHCP answer from 9.3.52.93, my address is 9.3.52.82
IP-Config: Complete:
device=eth0, addr=9.3.52.82, mask=255.255.255.224,
gw=255.255.255.255,
host=9.3.52.82, domain=austin.ibm.com, nis-domain=(none),
bootserver=9.3.52.93, rootserver=9.3.52.93, rootpath=
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
Looking up port of RPC 100003/2 on 9.3.52.93
Looking up port of RPC 100005/1 on 9.3.52.93
VFS: Mounted root (nfs filesystem).
Freeing unused kernel memory: 504k init 40k pmac 8k prep
Warning: unable to open an initial console.
Rolf
--
Rolf Brudeseth
pSeries System Engineering & Integration, IBM Enterprise Systems Group
Austin, TX
Reply to: