Hardware related

["Jeffrin Jose T." <jeffrin@msservices.org>]

Hello all,

 Does any boot parameter or parameters  require to boot a
 kernel  successfully when a typical  log related
 to  the Hard disk is shown below.




(scsi0) <Adaptec AIC-7896/7 Ultra2 SCSI host adapter> found at PCI 0/12/0
(scsi0) Wide Channel A, SCSI ID=7, 32/255 SCBs
(scsi0) Downloading sequencer code... 393 instructions downloaded
(scsi1) <Adaptec AIC-7896/7 Ultra2 SCSI host adapter> found at PCI 0/12/1
(scsi1) Wide Channel B, SCSI ID=7, 32/255 SCBs
(scsi1) Downloading sequencer code... 393 instructions downloaded
scsi: <fdomain> Detection failed (no card)
NCR53c406a: no available ports found
sym53c416.c: Version 1.0.0
Failed initialization of WD-7000 SCSI card!
DC390: 0 adapters found
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.33/3.2.4
       <Adaptec AIC-7896/7 Ultra2 SCSI host adapter>
scsi1 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.33/3.2.4
       <Adaptec AIC-7896/7 Ultra2 SCSI host adapter>
scsi : 2 hosts.
  Vendor: SEAGATE   Model: ST39175LC         Rev: 0001
  Type:   Direct-Access                      ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
(scsi0:0:0:2) Synchronous at 80.0 Mbyte/sec, offset 15.
  Vendor: ESG-SHV   Model: SCA HSBP M7       Rev: 0.08
  Type:   Processor                          ANSI SCSI revision: 02
scsi : detected 1 SCSI disk total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 17783240 [8683 MB] [8.7 GB]


-- 
Jeffrin Jose T.
www.MSServices.org
GPG:1024D/F5726A1B