[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: Install Pb With Raid controller

Sat, Jun 09, 2001 at 10:18:07PM +0200 wrote:
> I'm use an raid controller. This controller is used juste for a UDMA100
> hard drive, not for raid. The installation program, not recognize any
> hard drive, and i could not install the debian linux.


This may be a boot-floppies bug or a kernel-image bug, I'd like to figure out

1. Does the kernel recognize anything when you boot? [1]

2. If the kernel does recognize the drive, where in the installation program is
the drive not found?



[1] : the kernel recognizing would look something like this (just various drive
detections that occur on my own system I don't know what it should look like 
for your hardware but this is the general idea.) :

VP_IDE: IDE controller on PCI bus 00 dev 21
VP_IDE: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xb800-0xb807, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xb808-0xb80f, BIOS settings: hdc:DMA, hdd:DMA
hda: ST38410A, ATA DISK drive
hdc: Pioneer DVD-ROM ATAPIModel DVD-105S 011, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: ST38410A, 8223MB w/512kB Cache, CHS=1048/255/63
hdc: ATAPI DVD-ROM drive, 512kB Cache
Uniform CD-ROM driver Revision: 3.11
hdd: ATAPI 52X CD-ROM drive, 128kB Cache

Reply to: