Re: Fw: Usbnet. Ethernet gadget driver for Windows

Hi.

Thanks Simon, thanks Philippe.

"Code 10", this is standard error code generated by windows device manager, meaning that device cannot start.

Lsmod doesn't provide any information about driver.

It looks like g_cdc built in kernel. "Rmmod g_cdc" and than respectively "modprobe g_ether" doesn't affect.

Tomorrow I'll try to build the kernel according to this paper http://wiki.debian.org/InstallingDebianOn/TI/BeagleBone , changing config to RNDIS gadget support.

Best regards,
Dmitriy Alekseev

From: Philippe De Swert <philippedeswert@gmail.com>
To: Dmitry Alexeev <alexeev6@yahoo.com>
Cc: debian-arm@lists.debian.org
Sent: Thursday, April 12, 2012 1:08 PM
Subject: Re: Fw: Usbnet. Ethernet gadget driver for Windows

Hi,

On 09/04/2012, Dmitry Alexeev <alexeev6@yahoo.com> wrote:
> I netinstalled Debian Squeeze on Beaglebone's uSD card. (armv7, TI's am3359)
> Everything works perfectly, except setting network over usb on Windows 7 PC.
>
> I've tried to install driver with linux.inf file (attached below), but
> working fails with code 10.

Is this some windows error code?

And which driver are you loading on the beaglebone? g_ether?

Cheers,

Philippe

--
To UNSUBSCRIBE, email to debian-arm-REQUEST@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Archive: http://lists.debian.org/[🔎] CAPsFW+T4LACr4VsQ0dFfvi1T4Jnuyy1Yw2g+wHjth84Kr12GzA@mail.gmail.com

Reply to: