Iomega ix2-200
Hi all,
I've been experimenting a bit with installing Debian on my ix2-200.
I've managed to install a full system using the OpenRD installer and
arcNumber 1682 (the ix2-200 identifies itself as such during it's
factory boot sequence).
The installation runs fine, except for the "make system bootable" step
(flash is not at the same adress, or something, i guess), but when I
try to boot the kernel and initrd instaled on my boot partition I get
Bad Magic Number (see below)!?
The installation kernel obviously boots fine, any pointers to what
could be the problem?
(I'm happy to supply the installed kernel and initrd images on request...)
Kind regards,
Lars
Marvell>> ide reset
Reset IDE:
Marvell Serial ATA Adapter
Integrated Sata device found
[0 0 0]: Enable DMA mode
Device 0 @ 0 0:
Model: ST31000520AS Firm: CC37 Ser#:
5VX0ZAH5
Type: Hard Disk
Supports 48-bit addressing
Capacity: 953869.7 MB = 931.5 GB (1953525168 x 512)
[0 1 0]: Enable DMA mode
Device 1 @ 0 1:
Model: ST31000520AS Firm: CC37 Ser#:
5VX0Y76L
Type: Hard Disk
Supports 48-bit addressing
Capacity: 953869.7 MB = 931.5 GB (1953525168 x 512)
Marvell>> ext2ls ide 0:1
<DIR> 1024 .
<DIR> 1024 ..
<DIR> 12288 lost+found
1435120 vmlinuz-2.6.32-5-kirkwood
84134 config-2.6.32-5-kirkwood
<SYM> 28 initrd.img
<SYM> 25 vmlinuz
1004912 System.map-2.6.32-5-kirkwood
5480642 initrd.img-2.6.32-5-kirkwood
Marvell>> setenv bootargs 'console=ttyS0,115200 root=/dev/sdb3'
Marvell>> ext2load ide 0:1 0x01100000 /initrd.img
5480642 bytes read
Marvell>>
Marvell>> ext2load ide 0:1 0x00800000 /vmlinuz
1435120 bytes read
Marvell>>
Marvell>> bootm 0x00800000 0x01100000
## Booting image at 00800000 ...
Bad Magic Number
Marvell>>
--
Lars M. Johansson +46 (0)733 514 744
lars.m.johansson@gmail.com +46 (0)13 473 1012
Reply to: