R: Debian installer for SheevaPlug eSATA
Good day Martin.
The ( only ) installer works fine, but i'm not be able to boot the system after the installation.
This is the output:
***********************************************************
Marvell Serial ATA Adapter
Integrated Sata device found
[0 1 0]: Enable DMA mode
Device 1 @ 0 1:
Model: WDC WD1200BEVS-22RST0 Firm: 04.01G04 Ser#: WD-WXE808NWD688
Type: Hard Disk
Supports 48-bit addressing
Capacity: 114473.4 MB = 111.7 GB (234441648 x 512)
** Bad partition 1 **
** Bad partition 1 **
## Booting image at 00800000 ...
Bad Magic Number
Marvell>>
************************************************************
what have i done of wrong?
I'm using my Esata sheeva plug (new it ) with an Esata disc obviously.
________________________________________
Da: Martin Michlmayr [tbm@cyrius.com]
Inviato: venerdì 11 giugno 2010 16.04
A: debian-arm@lists.debian.org
Oggetto: Re: Debian installer for SheevaPlug eSATA
* Martin Michlmayr <tbm@cyrius.com> [2010-06-08 11:47]:
> Also, starting the installer is slightly different. You have to do it
> like this:
>
> setenv bootargs console=ttyS0,115200 base-installer/initramfs-tools/driver-policy=most apt-setup/local0/repository="http://people.debian.org/~tbm/orion lenny main" apt-setup/local0/key=http://people.debian.org/~tbm/orion/68FD549F
> bootm 0x00800000 0x01100000
The new kernel is in Debian testing now, so you can simply install
with:
setenv bootargs console=ttyS0,115200 base-installer/initramfs-tools/driver-policy=most
bootm 0x00800000 0x01100000
Can someone with a SheevaPlug eSATA confirm that this is working? If
so, I'll update my web site.
--
Martin Michlmayr
http://www.cyrius.com/
--
To UNSUBSCRIBE, email to debian-arm-REQUEST@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Archive: http://lists.debian.org/20100611140434.GA15399@jirafa.cyrius.com
Reply to: