Re: QNAP TS-219P: squeeze installer does not detect disks
On 1 July 2010 20:45, Michael Trim <mike.trim@gmail.com> wrote:
> Hello,
>
> I am attempting to install Debian testing on my new TS-219P. I have
> followed the instructions at [1], and have successfully launched the
> installer and set up the language, location, timezone etc., however
> the installer is unable to detect the installed hard disks. The
> installer hangs for some time at the "Detecting disks and all other
> hardware" screen, then shows the following screen:
>
>> [!] Detect disks
>>
>> No disk drive was detected. If you know the name of the driver needed by your disk drive, you can select it
>> from the list.
>>
>> Driver needed for your disk drive:
>>
>> continue with no disk drive
>> loop
>> scsi_dh
>> scsi_mod
>> sd_mod
>> sr_mod
>> none of the above
>
> I have tried each of the options above and none of them work.
>
> Both installed hard disks are Western Digital WD20EARS (2TB drives
> with 4KB sectors), and were detected and configured correctly with the
> QNAP firmware.
>
> Any ideas? Please CC me on any replies as I am not subscribed to the
> list, thanks.
>
> -- Michael Trim
>
> [1] http://www.cyrius.com/debian/kirkwood/qnap/ts-219/install.html
>
I also get the same behaviour with the stable/lenny installer.
-- Michael Trim
Reply to: