Cannot find init after debian install with squeeze

[mark@jumpingbean.co.za]

Hi all,

Following my last post I have copied the full error message I get. I can
mount /dev/md0 find under the shell provided and there is  a /sbin/init so
I assume the initrd image has some kind of mapping wrong for the root
partition. /dev/sda2 is a swap partition.



--------------------------------------------------------------

Begin: Mounting root file system ... Begin: Running /scripts/local-top ...
Begin: Loading[   12.560000] md: raid1 personality registered for level 1
Success: loaded module raid1.
done.
Begin: Assembling all MD arrays ... [   12.700000] md: md0 stopped.
[   12.810000] md: bind<sdb1>
[   12.810000] md: bind<sda1>
[   12.830000] raid1: raid set md0 active with 2 out of 2 mirrors
[   12.860000] md0: detected capacity change from 0 to 20003749888
[   12.860000]  md0: unknown partition table
mdadm: /dev/md0 has been started with 2 drives.
Success: assembled all arrays.
done.
done.
Begin: Running /scripts/local-premount ... done.
mount: mounting /dev/sda2 on /root failed: No such device
Begin: Running /scripts/local-bottom ... done.
done.
Begin: Running /scripts/init-bottom ... mount: mounting /dev on /root/dev
failed: No such file or directory
done.
mount: mounting /sys on /root/sys failed: No such file or directory
mount: mounting /proc on /root/proc failed: No such file or directory
Target filesystem doesn't have /sbin/init.
No init found. Try passing init= bootarg.