Re: debian install for KURO-SHEEVA
On 10.12.2009, at 01:54, "東 政一" <email@example.com>
I bought a KURO-SHEEVA released recently.
It is added one esata port to the Original SHEEVA-PLUG.
By using SD card 128mb, I installed the debian squeeze according to
But at the disk detection stage of the installation, a external disk
connected via esata port was never detected.
Being that the eSATA specification does not support powering disks
(power eSATA is something else), connected devices must be powered
I think the esata driver will be included in the base-installer.
Could you drop down into a shell and list the attached pci devices?
$ lspci -vv
Possibly, a different discrete PCI eSATA chip than that in the QNAP
TS-219P is being used. If this holds true, you may require another
eSATA kernel driver than the one supplied with the default debian
Please give me the suggestion for the solution.
To UNSUBSCRIBE, email to debian-arm-REQUEST@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact firstname.lastname@example.org
Cellent Finance Solutions AG
Firmensitz: Calwer Straße 33, 70173 Stuttgart
Registergericht: Amtsgericht Stuttgart, HRB 720743
Vorstand: Thomas Wild
Vorsitzender des Aufsichtsrats: Rudolf Zipf