Bricked Sheevaplug
In my hurry to get Debian on to my Sheevaplug, I stupidly said "yes" to
changing the envs config when attempting to upgrade U-boot to cope with
SD cards (as per the bottom of the page at www.cyrius.com).
I've reflashed U-boot using the Sheevaplug alpha 6 installer - I have a
working U-boot but it fails with
---cut here---
Marvell>> reset
▒
__ __ _ _
| \/ | __ _ _ ____ _____| | |
| |\/| |/ _` | '__\ \ / / _ \ | |
| | | | (_| | | \ V / __/ | |
|_| |_|\__,_|_| \_/ \___|_|_|
_ _ ____ _
| | | | | __ ) ___ ___ | |_
| | | |___| _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
\___/ |____/ \___/ \___/ \__|
** MARVELL BOARD: SHEEVA PLUG LE
U-Boot 1.1.4 (Apr 29 2009 - 13:10:05) Marvell version: 3.4.16
U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CF100
Soc: 88F6281 A0 (DDR2)
CPU running @ 1200Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz
DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000 size 256MB
DRAM CS[1] base 0x10000000 size 256MB
DRAM Total size 512MB 16bit width
Flash: 0 kB
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:512 MB
*** Warning - bad CRC or NAND, using default environment
CPU : Marvell Feroceon (Rev 1)
Streaming disabled
Write allocate disabled
USB 0: host mode
PEX 0: interface detected no Link.
Net: egiga0 [PRIME], egiga1
Hit any key to stop autoboot: 0
Using egiga0 device
TFTP from server 10.4.50.5; our IP address is 10.4.50.165
Filename 'uImage'.
Load address: 0x2000000
Loading: T T T T T T T T T T
Retry count exceeded; starting again
## Booting image at 02000000 ...
Bad Magic Number
Unknown command '<NULL>' - try 'help'
Marvell>>
---cut here---
"Help, I've broken it HELP HELP!" sagt Andy
Zu hilfe, bitte,
AndyC
Reply to: