Re: [Debian-Arm] Re: debian 5.0beta2 image dose not boot on NSLU2
Martin Michlmayr schrieb:
> * Steve Wagner <lists@lanwin.de> [2008-08-06 17:17]:
>> Set slug is set to an static ip adress, but i dont know where i dose
>> this. So i can not check if the data is correct. But the SlugOSLE
>> image boots after flashing without changes on the network
>> configuration and is available on the network address i set before.
>>
>> How can i get the debian 5.0beta2 to boot?
>
> Isn't this essentially the same message you posted to the nslu2-linux?
> I'm not sure why you'll get better responses here.
Sorry for the double post, but it did get there no answers, only
questions and i am not sure which list is best for such a question.
> The most likely explanation is that your static network configuration
> is not complete. If this is the case, the installer will not start.
> There might be other reasons but without a serial console it's
> impossible to say.
>
> The network configuration is stored in a MTD partition called SysConf.
> You should be able to change the network configuration with SlugOS
> (either complete the static config, or change it to use DHCP) and then
> to flash debian-installer again.
Thx for that information. I will try to change that and flash again.
Steve
Reply to: