n2100 crash...
Hello,
I use lenny (arm, not armel) in my Thecus N2100 with 2 1TB disks and
raid1 (mirroring).
Sometimes my box hangs without any noticeable reason... I can see only
these messages on console:
md: data-check of RAID array md0
md: minimum _guaranteed_ speed: 1000 KB/sec/disk.
md: using maximum available idle IO bandwidth (but not more than 200000
KB/sec) for data-check.
md: using 128k window, over a total of 14651136 blocks.
md: delaying data-check of md1 until md0 has finished (they share one or
more physical units)
md: md0: data-check done.
md: data-check of RAID array md1
md: minimum _guaranteed_ speed: 1000 KB/sec/disk.
md: using maximum available idle IO bandwidth (but not more than 200000
KB/sec) for data-check.
md: using 128k window, over a total of 961128704 blocks.
RAID1 conf printout:
--- wd:2 rd:2
disk 0, wo:0, o:1, dev:sda1
disk 1, wo:0, o:1, dev:sdb1
md: md1: data-check done.
RAID1 conf printout:
--- wd:2 rd:2
disk 0, wo:0, o:1, dev:sda3
disk 1, wo:0, o:1, dev:sdb3
drivers/usb/class/usblp.c: usblp0: removed
Any ideas?
--
Przemyslaw Kwiatkowski [Micha], micha@micha.waw.pl, 2:480/127@FidoNet
SMS# +48 601 238089, GPG: 2CA0 F353 85FD B0F1 1BD4 73D7 F85D 2717
"Any technology distinguishable from magic is insufficiently advanced."
(c) Gregory Benford
Reply to: