Re: second hard disk on Thecus N2100
On Saturday 10 November 2007 18:51, you wrote:
> * Thomas Winter <thowinter@googlemail.com> [2007-11-10 18:34]:
> > am running debian etch on Thecus N2100 with one SATA disk. I tried
> > to add an second SATA, but Thecus did not boot, nothing in syslog.
> >
> > Any trick to add an second hard disk?
>
> Hard to tell without any logs, but I guess the box tried to mount root
> on the wrong disk and failed. Remove the 2nd drive again, and update
> /etc/fstab to use UUID. Read section "The slug fails to reboot with 2
> drives connected" at http://www.nslu2-linux.org/wiki/Debian/TroubleShooting
> for some instructions. (This is for the Linksys NSLU2 but the same
> applies to the Thecus N2100.)
thanks, that could be the case
I tried
#update-initramfs -u
I got this message
/boot/initrd.img-2.6.18-4-iop32x has been altered. Cannot update.
# aptitude upgrade
The following packages have been kept back:
linux-image-2.6-iop32x
Also Iam concerned that if I change to uuid and the hard disk goes defect I
can not change to another hard disk.
Can I expect that serial console is working? I did not solder an connector to
the pcb until now and did not test.
Reply to: