i-cubed EtherH on RiscPC: Lost interrupt
Hello,
I can't get to work an i-cubed EtherH 600 network card on my RiscPC
700. When I try pinging another machine from the RiscPC, I can
see the first ARP discover frame on the network, but then the EtherH
driver complains "Tx timed out, lost interrupt". Incoming frames are
not detected at all.
Under RISC OS, the card works OK. In its flash, it has the 4.41 RISC
OS EtherH module. The RiscPC's kernel is 2.4.3.
What can I do? I'd really like to get this to work!
Many thanks for any help!!
Richard
----------------------------------------------------------------------
# modprobe etherh
eth0: i3 EtherH 600 in slot 8, 00:c0:32:00:65:ce
# ifconfig eth0 192.168.1.2
# ifconfig eth0
eth0 Link encap:Ethernet HWaddr 00:C0:32:00:65:CE Media:10baseT(auto)
inet addr:192.168.1.2 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:11 Base address:0xae00 Memory:8000ae10-ec
# cat /proc/bus/ecard/devices
8: [0046:00EC] Design IT E600 Access+ (00:c0:32:00:65:CE)
# ping 192.168.1.1
PING 192.168.1.1 (192.168.1.1): 56 data bytes
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Tx timed out, lost interrupt? TSR=0x1, ISR=0x3, t=2128.
# cat /proc/interrupts
3: 213918 console/cursor, mouse
5: 356418 timer
9: 45547 ide0
10: 1 serial
11: 0 eth0
13: 0 expansion cards
14: 0 keyboard
15: 2554 keyboard
Err: 0
--
__ _
|_) /| Richard Atterer | CS student at the Technische | GnuPG key:
| \/¯| http://atterer.net | Universität München, Germany | 0x888354F7
¯ ´` ¯
Reply to: