df shows incorrect size for ext3 RAID 6 partition
I am running etch on a new RAID storage server with an Adaptec RAID 31605
controller. The setup is using RAID 6 with 500GB drives. The actual size
of the RAID 6 partition is 5832719MB but when mounted df shows is at as
1.3TB which is incorrect. Is there some option that I am missing some
option which might be causing this. Any help on this is appreciated.
dmesg output:
[ 101.209427] scsi 6:0:0:0: Direct-Access Adaptec RAID
V1.0 PQ
: 0 ANSI: 2
[ 101.209588] sd 6:0:0:0: [sdc] Very big device. Trying to use READ
CAPACITY(16
).
[ 101.209619] sd 6:0:0:0: [sdc] 11392225280 512-byte hardware sectors
(5832819
MB)
[ 101.209623] sd 6:0:0:0: [sdc] Assuming Write Enabled
[ 101.209626] sd 6:0:0:0: [sdc] Assuming drive cache: write through
[ 101.209784] sd 6:0:0:0: [sdc] Very big device. Trying to use READ
CAPACITY(16
).
[ 101.209811] sd 6:0:0:0: [sdc] 11392225280 512-byte hardware sectors
(5832819
MB)
[ 101.209814] sd 6:0:0:0: [sdc] Assuming Write Enabled
[ 101.209815] sd 6:0:0:0: [sdc] Assuming drive cache: write through
[ 101.209821] sdc: sdc1
[ 101.297629] success
output of "df -hT"
/dev/sdc1 ext3 1.3T 379G 870G 31% /raid
Thanks,
Bharath
---
Bharath Ramesh <bramesh@vt.edu> http://people.cs.vt.edu/~bramesh
Reply to: