iti-4120
I just tried putting an iti-4280 in a AlphaServer and encountered the
following problem. The controller is configure with 5 disks on the A bus
and 3 disks on the second bus. From SRM I can see all 8 disks, but when
Linux boots it creates 4 disk devices, two from the first bus and two from
the second bus. Does this make any sense? When I put 7 of the disks on a
single iti-4140, all seven are seen and the system boots just fine. I
would appreciate any insights.
Bill
+---------------------------------------------------
| Bill MacAllister
| 14219 Auburn Road
| Grass Valley, CA 95949
Reply to: