Re: sym1:0: wide asynchronous
On Sun, May 22, 2005 at 08:56:40PM +0200, mn wrote:
>
> I'm using the generic 2.6.10-Kernel on my AlphaStation 255/300. I boot
> from a disk which is connected to a additional SCSI-Controller
> (LSI8952U). When I look into dmesg it see the following lines:
>
> sym1: Symbios NVRAM, ID 7, Fast-40, LVD, parity checking
> Vendor: IBM Model: DDYS-T09170N Rev: SA2A
> Type: Direct-Access ANSI SCSI revision: 03
> sym1:0: wide asynchronous.
>
> Because the async mode is used I only get 14MB/s. How can I set it to
> sync mode. I'm new to the Alpha and SCSI-world.
Isn't there a jumper at the harddisk to set the sync mode on/off?
martin
Reply to: