Re: Promise Controller
Well there goes a reboot for nothing... it was already in a 32bit pci
slot. The only thing i have in a 64bit pci slot is my video card. Any
other ideas?
Richard Fillion
rick@rhix.ods.org
On Sun, Mar 30, 2003 at 01:42:39PM -0500, Jay Estabrook wrote:
> On Sat, Mar 29, 2003 at 09:01:31PM -0600, Richard Fillion wrote:
> >
> > I'm trying to get a Promise controller working in my PWS500au, and i'm
> > not having very good luck. The controller works cause i used it once in
> > my celeron, and it works with linux/alpha cause i used to use it in my
> > DS3305 to get this same drive to work. Here's what the kernel spits out
> > before it stops at boot:
> >
> > ide0 at 0x1f0-0x1f7, 0x3f6 on irq 14
> > ide2 at 0x8410-0x8417, 0x8422 on irq 44
> > blk: queue fffffc0000658080, no I/O memory limit.
> > hdf: 117231408 sectors (60022MB) w/ 2048KiB cache, CHS 116301/16/63
> > UDMA(100)
> > hda: ATAPI 32x CD-ROM drive 256kb cache, DMA
> > Uniform CD-ROM driver Revision 3.12
> > Parition check:
> > hdf: hdf: dma_intr: status 0x51 {DriveReady SeekComplete Error}
> > hdf: dma_intr: error 0x84 {DriveStatus Error Bad CRC}
> >
> > And then it just sits there...
>
> Is the PROMISE card in a 32-bit or 64-bit slot?
>
> If the latter, put it in the former and try again. There are known
> DMA problems on PWS when using nthe 64-bit slots.
>
> --Jay++
>
> -----------------------------------------------------------------------------
> Jay A Estabrook HPTC - LINUX support
> Hewlett-Packard Company - MRO1-2/K15 (508) 467-2080
> 200 Forest Street, Marlboro MA 01752 Jay.Estabrook@hp.com
> -----------------------------------------------------------------------------
Reply to: