Re: Centris 650 Debian 10 SID Installation
On Thu, 13 Jun 2019, Andreas Schwab wrote:
> On Jun 13 2019, Finn Thain <fthain@telegraphics.com.au> wrote:
>
> > IMHO these log messages are a bit silly --
> >
> > [ **] (3 of 3) A start job is running for /dev/sda4 (1min 5s / 1min 36s)
> > ...
> > [ TIME ] Timed out waiting for device /dev/sda4.
> > [DEPEND] Dependency failed for /dev/sda4.
> > [DEPEND] Dependency failed for Swap.
> > ...
> > Activating swap /dev/sda4...
> > ...
> > [ 450.650000] Adding 524284k swap on /dev/sda4. Priority:-2 extents:1 across:524284k FS
> > ...
> > [ OK ] Activated swap /dev/sda4.
>
> That just means that the timeout is maybe too short,
Adding swap isn't that complicated.
If you have you swap partition on MD RAID ROCE, I'd hazard a guess that
you aren't using Linux/m68k for that. This is a use-case that systemd
should probably cater to. But making everyone pay for that complexity is
poor design IMHO.
> but if a device is showing up late it is handled like hotplug and works
> anyway.
>
The device isn't late, swapon() is late (compared to Debian 3 or Debian
4).
[ 206.380000] sda: [mac] sda1 sda2 sda3 sda4 sda5 sda6 sda7 sda8 sda9 sda10
...
[ 206.790000] sd 0:0:0:0: [sda] Attached SCSI disk
...
[ 243.400000] systemd[1]: systemd 241 running in system mode. (+PAM
+AUDIT +SELINUX +IMA +APPARMOR +SMACK +SYSVINIT +UTMP +LIBCRYPTSETUP
+GCRYPT +GNUTLS +ACL +XZ +LZ4 -SECCOMP +BLKID +ELFUTILS +KMOD -IDN2 +IDN
-PCRE2 default-hierarchy=hybrid)
--
> Andreas.
>
Reply to: