scsi problem on a quadra 950
i installed the mac installation archives from the debian ftp (penguin,
etc), everything worked fine until the first boot.
linux boots up, detects the scsi bus and devices and than complains
about problems with the scsi-bus:
--------------------------------------------------------------------------
mac_esp: io base at 0x50f0f000
esp: using quick version
esp: addr at 0x50f0f000
SCSI ID 7 Clk 25MHz CCF=5 TOut 167 NCR53C9x(esp236)
mac_esp: io base at 0x50f0f402
SCSI ID 7 Clk 25MHz CCF=5 TOut 167 NCR53C9x(esp236)
mac_esp: 2esp controllers found
scsi0 : ESP236 (NCR53C9x)
scsi1 : ESP236 (NCR53C9x)
scsi : 2 hosts.
esp0: hoping for msgout
Vendor: FUJITSU Model: M2624F-512 Rev: 0404
Type: Direct-Access ANSI SCSI revision: 01 CCS
Detected scsi disk sda at scsi0, channel 0, id 1, lun 0
scsi : aborting command due to timeout : pid 8, scsi1, channel 0, id 0, \
lun 0 Test Unit Ready 00 00 00 00 00
esp1: Aborting command
esp1: dumping state
esp1: SW [sreg<00> sstep<00> ireg<00>]
esp1: HW reread [sreg<00> sstep<c0> ireg<00>]
esp1: current command [tgt<00> lun<00> pphase<UNISSUED> cphase<SLCTNORM>]
esp1: disconnected
SCSI host 1 abort (pid 8) timed out - resetting
SCSI bus is being reset for host 1 channel 0.
esp1: Resetting scsi bus
SCSI host 1 abort (pid 8) timed out - resetting
SCSI bus is being reset for host 1 channel 0.
esp1: Resetting scsi bus
SCSI host 1 reset (pid 8) timed out again -
probably an unrecoverable SCSI bus or device hang.
--------------------------------------------------------------------------
it looks like it's the 2nd (the external) scsi bus. i don't need this
one, can i simply disable it? how is that done?
maybe it's a hardware problem, i don't know if i need a terminator on
the external scsi bus, if there's no device on it.
tibor
--
Tibor Csögör t.csoegoer@ms-compuservice.de
MS-CompuService http://www.ms-compuservice.de
Münster Str. 1h Tel.: +49 2306 966850
44534 Lünen Fax : +49 2306 966852
Reply to: