Re: NetXtreme BCM5722 strangeness on Proliant ML115
On Mon, 09 Jul 2012 17:31:46 +0100, Berni Elbourn wrote:
> On 09/07/12 15:14, Camaleón wrote:
(...)
>> Despite the small number of dropped packages (26) the total ammount of
>> received packages is also very low (15.1 MiB), there shouldn't be a
>> single drop.
>>
>> Is "dmesg | grep -i eth0" showing any anomaly?
>>
>>
>>
> I'll give the code from the broadcom website a wiz...just for the record
> here is the status after a few hours of use:
>
> # sudo ifconfig eth0
> eth0 Link encap:Ethernet HWaddr 00:21:5a:d3:d0:0c
> inet addr:192.168.2.10 Bcast:192.168.2.255
> Mask:255.255.255.0 inet6 addr: fe80::221:5aff:fed3:d00c/64
> Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:14050436 errors:0 dropped:26 overruns:0 frame:2 TX
> packets:3730779 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:1000
> RX bytes:20348704555 (18.9 GiB) TX bytes:614582976 (586.1
> MiB) Interrupt:19
That's more reasonable as there are no additional dropped packages but
traffic has increased a lot.
> # dmesg | grep eth0
> [ 1.191804] e100 0000:02:04.0: eth0: addr 0xfafff000, irq 18, MAC addr 00:90:27:b0:0a:7d
> [ 6.508590] udev[474]: renamed network interface eth1 to eth1-eth0
> [ 6.532526] udev[470]: renamed network interface eth0 to eth1
> [ 6.584538] udev[474]: renamed network interface eth1-eth0 to eth0
> [ 11.677058] ADDRCONF(NETDEV_UP): eth0: link is not ready
> [ 14.772314] tg3 0000:11:00.0: eth0: Link is up at 1000 Mbps, full duplex
> [ 14.772319] tg3 0000:11:00.0: eth0: Flow control is on for TX and on for RX
> [ 14.772698] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
> [ 25.520006] eth0: no IPv6 routers present
Beyond the "swaping dance" (eth1 → eth0) the rest looks normal.
I would keep monitoring the interface and the number of dropped packages
for a while, but regardless the backported kernel is working fine, I'd
open a bug report so kernel developers review this.
Greetings,
--
Camaleón
Reply to: