Re: ide: failed opcode was: unknown
James Vahn <jvahn@short.circuit.com> writes:
> Alexandru Cardaniuc wrote:
> > Enabled Supported: * NOP cmd * READ BUFFER cmd * WRITE BUFFER
> >cmd * Host Protected Area feature set * Look-ahead Write cache *
> >Power Management feature set Security Mode feature set SMART feature
> >set
> ^^^^^^^^^^^^^^^^^ Disabled. Turn SMART on in your
> BIOS and run the selftest via smartctl.
I installed smartmontools, set in /etc/default/smartmontools
enable_smart="/dev/hda"
start_smartd=yes
I will try now to run 2 tests:
# smartctl -C -t short /dev/hda
# smartctl -C -t long /dev/hda
and later on will send the results.
But right now I already checked # smartctl -a /dev/hda
I attach smartctl.txt with the output.
smartctl version 5.34 [x86_64-unknown-linux-gnu] Copyright (C) 2002-5 Bruce Allen
Home page is http://smartmontools.sourceforge.net/
=== START OF INFORMATION SECTION ===
Device Model: TOSHIBA MK8025GAS
Serial Number: 24580773A
Firmware Version: KA023A
User Capacity: 80,026,361,856 bytes
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: 6
ATA Standard is: Exact ATA specification draft version not indicated
Local Time is: Thu Nov 3 07:24:27 2005 PST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: FAILED!
Drive failure expected in less than 24 hours. SAVE ALL DATA.
See vendor-specific Attribute list for failed Attributes.
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 41) The self-test routine was interrupted
by the host with a hard or soft reset.
Total time to complete Offline
data collection: ( 375) seconds.
Offline data collection
capabilities: (0x1b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
No Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
No General Purpose Logging support.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 75) minutes.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000b 100 100 050 Pre-fail Always - 0
2 Throughput_Performance 0x0005 100 100 050 Pre-fail Offline - 0
3 Spin_Up_Time 0x0027 100 100 001 Pre-fail Always - 1123
4 Start_Stop_Count 0x0032 100 100 000 Old_age Always - 736
5 Reallocated_Sector_Ct 0x0033 001 001 050 Pre-fail Always FAILING_NOW 1023
7 Seek_Error_Rate 0x000b 100 100 050 Pre-fail Always - 0
8 Seek_Time_Performance 0x0005 100 100 050 Pre-fail Offline - 0
9 Power_On_Hours 0x0032 087 087 000 Old_age Always - 5577
10 Spin_Retry_Count 0x0033 114 100 030 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 671
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 68
193 Load_Cycle_Count 0x0032 089 089 000 Old_age Always - 116388
194 Temperature_Celsius 0x0022 100 100 000 Old_age Always - 46 (Lifetime Min/Max 17/57)
196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 692
197 Current_Pending_Sector 0x0032 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0030 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x0032 200 200 000 Old_age Always - 11
220 Disk_Shift 0x0002 100 100 000 Old_age Always - 8279
222 Loaded_Hours 0x0032 088 088 000 Old_age Always - 4822
223 Load_Retry_Count 0x0032 100 100 000 Old_age Always - 0
224 Load_Friction 0x0022 100 100 000 Old_age Always - 0
226 Load-in_Time 0x0026 100 100 000 Old_age Always - 209
240 Head_Flying_Hours 0x0001 100 100 001 Pre-fail Offline - 0
SMART Error Log Version: 1
ATA Error Count: 3143 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 3143 occurred at disk power-on lifetime: 5576 hours (232 days + 8 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 24 ec 7d ba e3 Error: UNC 36 sectors at LBA = 0x03ba7dec = 62553580
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 64 ac 7d ba e3 00 02:44:40.020 READ DMA
c8 00 65 ab 7d ba e3 00 02:44:31.591 READ DMA
c8 00 66 aa 7d ba e3 00 02:44:23.149 READ DMA
c8 00 67 a9 7d ba e3 00 02:44:14.720 READ DMA
c8 00 68 a8 7d ba e3 00 02:44:06.292 READ DMA
Error 3142 occurred at disk power-on lifetime: 5576 hours (232 days + 8 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 24 ec 7d ba e3 Error: UNC 36 sectors at LBA = 0x03ba7dec = 62553580
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 65 ab 7d ba e3 00 02:44:31.591 READ DMA
c8 00 66 aa 7d ba e3 00 02:44:23.149 READ DMA
c8 00 67 a9 7d ba e3 00 02:44:14.720 READ DMA
c8 00 68 a8 7d ba e3 00 02:44:06.292 READ DMA
c8 00 69 a7 7d ba e3 00 02:43:57.864 READ DMA
Error 3141 occurred at disk power-on lifetime: 5576 hours (232 days + 8 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 24 ec 7d ba e3 Error: UNC 36 sectors at LBA = 0x03ba7dec = 62553580
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 66 aa 7d ba e3 00 02:44:23.149 READ DMA
c8 00 67 a9 7d ba e3 00 02:44:14.720 READ DMA
c8 00 68 a8 7d ba e3 00 02:44:06.292 READ DMA
c8 00 69 a7 7d ba e3 00 02:43:57.864 READ DMA
c8 00 6a a6 7d ba e3 00 02:43:49.435 READ DMA
Error 3140 occurred at disk power-on lifetime: 5576 hours (232 days + 8 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 24 ec 7d ba e3 Error: UNC 36 sectors at LBA = 0x03ba7dec = 62553580
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 67 a9 7d ba e3 00 02:44:14.720 READ DMA
c8 00 68 a8 7d ba e3 00 02:44:06.292 READ DMA
c8 00 69 a7 7d ba e3 00 02:43:57.864 READ DMA
c8 00 6a a6 7d ba e3 00 02:43:49.435 READ DMA
c8 00 6b a5 7d ba e3 00 02:43:41.007 READ DMA
Error 3139 occurred at disk power-on lifetime: 5576 hours (232 days + 8 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 24 ec 7d ba e3 Error: UNC 36 sectors at LBA = 0x03ba7dec = 62553580
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 68 a8 7d ba e3 00 02:44:06.292 READ DMA
c8 00 69 a7 7d ba e3 00 02:43:57.864 READ DMA
c8 00 6a a6 7d ba e3 00 02:43:49.435 READ DMA
c8 00 6b a5 7d ba e3 00 02:43:41.007 READ DMA
c8 00 6c a4 7d ba e3 00 02:43:32.579 READ DMA
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Extended captive Interrupted (host reset) 90% 5577 -
# 2 Extended captive Interrupted (host reset) 90% 5577 -
# 3 Short captive Interrupted (host reset) 90% 5577 -
# 4 Short captive Interrupted (host reset) 90% 5577 -
# 5 Extended offline Aborted by host 90% 5577 -
# 6 Short offline Completed without error 00% 5577 -
# 7 Extended offline Completed without error 00% 5563 -
# 8 Short offline Completed without error 00% 5562 -
# 9 Short offline Completed without error 00% 5561 -
#10 Short offline Completed without error 00% 78 -
Device does not support Selective Self Tests/Logging
>From the output it seems like it's failing. Why the tests that I ran
earlier today in the BIOS were successful and didn't indicate any
problem?
Then what is the final verdict? Throw the hard drive away?
--
"But what has been said once can always be repeated."
- Zeno of Elea
Reply to: