Re: Using a IDE CD-RW with a SCSI Hard Drive
On Wed, 10 Jul 2002, Jamin W. Collins wrote:
> Hmmm, how's your dmesg output look on startup? I have the following:
>
> scsi1 : SCSI host adapter emulation for IDE ATAPI devices
> Vendor: Lite-On Model: LTN483S 48x Max Rev: PD02
> Type: CD-ROM ANSI SCSI revision: 02
> Vendor: SONY Model: CD-RW CRX140E Rev: 1.0n
> Type: CD-ROM ANSI SCSI revision: 02
> Attached scsi CD-ROM sr0 at scsi1, channel 0, id 0, lun 0
> Attached scsi CD-ROM sr1 at scsi1, channel 0, id 1, lun 0
>
> when ide-scsi support is loaded.
It only lists the first line:
scsi1 : SCSI host adapter emulation for IDE ATAPI devices
There are no drives listed unlink when the aic7xxx driver loads:
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.4
<Adaptec 2940A Ultra SCSI adapter>
aic7860: Ultra Single Channel A, SCSI Id=7, 3/253 SCBs
Vendor: QUANTUM Model: FIREBALL ST4.3S Rev: 0F0C
Type: Direct-Access ANSI SCSI revision: 02
scsi0:A:6:0: Tagged Queuing enabled. Depth 8
Attached scsi disk sda at scsi0, channel 0, id 6, lun 0
I hope this helps.
-- Robert
--
------------------------------------------------------------------
Robert James Kaes --- Flarenet Inc. --- (519) 426-3782
http://www.flarenet.com/
* Putting the Service Back in Internet Service Provider *
------------------------------------------------------------------
--
To UNSUBSCRIBE, email to debian-user-request@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Reply to: