lilo and OpenBSD
Hello debian-user,
I have got 2 harddrives
hda with Debian
hdb with OpenBSD
now I am trying to config lilo
so that I am to boot into OpenBSD
but when adding:
other=/dev/hdb1
label=OpenBSD
read-only
alias=3
to lilo.conf
and run: lilo
the output looks like that:
Skipping /vmlinuz.old
Device 0x0340: Invalid partition table, 1st entry
3D address: 0/0/0 (-1)
Linear address: 1/0/0 (0)
it seems that lilo can't recognize hdb
I tried: cfdisk hdb
FATAL ERROR: Cannot open disk drive
Press any key to exit cfdisk
when I pull off the ide cable of my hda my pc boot
into OpenBSD so OpenBSD was installed probably
what should I modify in lilo.conf so I can boot into OpenBSD??
--
Best regards,
Kang-Ling mailto:jkdebian@gmx.net
--
To UNSUBSCRIBE, email to debian-user-request@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Reply to: