Problems with the shaper modules.
Hello.
i am trying to set up the shaper modules, following the istructions that
I found with the linux kernel, without any success, so I have some questions:
- I need in any case two or more network adapter ? (there is nothing
to say yes or not into the docs)
- I configured ip_alias, ip_forward and traffic shaper, there is anything else
I need to activate in the kernel ?
- I follow the man pages and use this options:
shapecfg attach shaper0 eth0
shapecfg speed shaper0 64000
ifconfig shaper0 [my_ip] netmask [my_netmask] broadcast [my_broad] up
route add -net [my_net] netmask [my_mask] dev shaper0
but it does not work.
The main difference is that I am trying on the eth0 dev, and the docs say to
use eth1, so I think I need two network adapters, Am I correct ?
Someone can suggest at least some documentation about this problem (i already
check the kernel documentation and the docs of the shapecfg program).
Thanks in advance
bye
Gianluca
--
Home Page Contro i brevetti del sw Boicotta Microsoft
www.infinito.it/utenti/chewbe no-patents.prosa.it/ www.boycott-ms.org/
"If we have to file a thousand lawsuits a day, we'll do it.
It's less expensive than losing CONTROL of YOUR creative works."
---Jack Valenti, President and CEO, Motion Picture Association of America
Reply to: