Re: setting up ethernet 3com 3509b card
I have run the 3509b successfully with both Debian and W95.
I configured the card out of PnP mode and specified the port
(i.e. coax or 10base-T). When
configured this way, Linux sees my card without trouble, and
I just had to delete and install the card's driver in W95 to get
it to work there. However, I still have to press the
reset button between Linux and W95 to get W95 to see it properly
(I haven't been able to solve this problem).
On 28-Apr-98 Ardo van Rangelrooij wrote:
> A collegue of mine had the same problem. The solution that worked (at
> least for him :-) was to "dipswitch" the card to non-PnP and voila! it
> worked. Only Win95 did not accept the card anymore (even not manual
> configuration!), but that was not important. Hope this helps!
> Marcus Brinkmann <Marcus.Brinkmann@ruhr-uni-bochum.de> writes:
>> I had trouble setting up an EtherlinkII 3com 3509b card with 2.0.32 and
>> 2.0.33 kernel. I configured pnp, compiled the right driver as module, but
>> the module gives me either initialization failed or symbol not found when
>> specifying io=0x210 irq=3...
>> Any help is appreciated.
To UNSUBSCRIBE, email to email@example.com
with a subject of "unsubscribe". Trouble? Contact firstname.lastname@example.org