Re: Probleme beim brennen mit K3b
Roland Schmid schrieb:
> Hallo,
>
> Am Freitag, den 14.03.2008, 21:51 +0100 schrieb Daniel Herbort:
>
>> Error trying to open /dev/sg1 exclusively (Device or resource busy)...
>
> sieht nach dem CD/DVD Device aus.
> Sitzen alle Kabel richtig?
Moin
Jep, Kabel sitzen alle schließlich kann ich ganz normal CDs und DVDs
lesen usw. Alles kein Problem. Ich habe eben nochmal einen Brennversuch
gestartet. War zwar auch nicht erfolgreicher aber die Fehlermeldung ist
diesmal eine andere:
"Es ist ein Fehler aufgetreten."
"Manchmal hilft es den TAO-Modus zu verwenden"
Wenn ich dann den TAO-Modus verwende kommt die Meldung welche ich schon
gestern beschrieben habe
Beim Fortschrittsbalken zeigt er an, das er die erste Datei brennen will
und fast direkt im Anschluß erscheint dort die Medlung, dass die Sitzung
geschlossen wird.
Hier nochmal die detaillierte Ausgabe von K3b:
System
-----------------------
K3b Version: 0.12.17
KDE Version: 3.5.5
QT Version: 3.3.7
Kernel: 2.6.24-1-amd64
Devices
-----------------------
HL-DT-ST DVDRAM GH20NS10 EL00 (/dev/scd0, /dev/sg1) at /media/cdrom0
[CD-R; CD-RW; CD-Rom; DVD-Rom; DVD-Ram; DVD-R; DVD-RW; DVD-R
doppelschichtig; DVD+R; DVD+RW; DVD+R doppelschichtig] [DVD-Rom; DVD-R
Sequentiell; Zweischichtige DVD-R Sequentiell; Zweischicht-DVD-R Sprung;
DVD-Ram; DVD-RW Eingeschränktes Überbrennen; DVD-RW Sequentiell; DVD+RW;
DVD+R; DVD+R Doppelschicht; CD-Rom; CD-R; CD-RW] [SAO; TAO; RAW;
SAO/R96P; SAO/R96R; RAW/R16; RAW/R96P; RAW/R96R; Eingeschränktes
Überschreiben; Sprung zwischen DVD-Schichten]
K3b
-----------------------
Size of filesystem calculated: 310363
Used versions
-----------------------
cdrecord: 2.1.1a03
cdrecord
-----------------------
scsidev: '1,0,0'
scsibus: 1 target: 0 lun: 0
Linux sg driver version: 3.5.34
Wodim version: 1.1.2
SCSI buffer size: 64512
Beginning DMA speed test. Set CDR_NODMATEST environment variable if device
communication breaks or freezes immediately after that.
TOC Type: 1 = CD-ROM
Driveropts: 'burnfree'
atapi: 1
Device type : Removable CD-ROM
Version : 5
Response Format: 2
Capabilities :
Vendor_info : 'HL-DT-ST'
Identification : 'DVDRAM GH20NS10 '
Revision : 'EL00'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0009 (CD-R)
Profile: 0x0012 (DVD-RAM)
Profile: 0x0011 (DVD-R sequential recording)
Profile: 0x0015 (DVD-R/DL sequential recording)
Profile: 0x0016 (DVD-R/DL layer jump recording)
Profile: 0x0014 (DVD-RW sequential recording)
Profile: 0x0013 (DVD-RW restricted overwrite)
Profile: 0x001A (DVD+RW)
Profile: 0x001B (DVD+R)
Profile: 0x002B (DVD+R/DL)
Profile: 0x0010 (DVD-ROM)
Profile: 0x0009 (CD-R) (current)
Profile: 0x000A (CD-RW)
Profile: 0x0008 (CD-ROM)
Profile: 0x0002 (Removable disk)
Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 1053696 = 1029 KB
Drive DMA Speed: 16626 kB/s 94x CD 12x DVD
FIFO size : 12582912 = 12288 KB
Speed set to 2822 KB/s
Track 01: data 606 MB
Total size: 696 MB (68:58.17) = 310363 sectors
Lout start: 696 MB (69:00/13) = 310363 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 4
Is not unrestricted
Is not erasable
Disk sub type: Medium Type A, high Beta category (A+) (3)
ATIP start of lead in: -11077 (97:34/23)
ATIP start of lead out: 359848 (79:59/73)
Disk type: Long strategy type (Cyanine, AZO or similar)
Manuf. index: 11
Manufacturer: Mitsubishi Chemical Corporation
Blocks total: 359848 Blocks current: 359848 Blocks remaining: 49485
Starting to write CD/DVD at speed 16.0 in dummy SAO mode for single
session.
Last chance to quit, starting dummy write in 2 seconds.
1 seconds.
0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
Sending CUE sheet...
Errno: 5 (Input/output error), write_g1 scsi sendcmd: no error
CDB: 2A 00 FF FF FF 6A 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0A 2A 00 00 80 30 05 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x30 Qual 0x05 (cannot write medium - incompatible format)
Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.002s timeout 200s
Writing pregap for track 1 at -150
write track pad data: error after 0 bytes
BFree: 1029 K BSize: 1029 K
Starting new track at sector: 0
Track 01: 0 of 606 MB written.
Errno: 5 (Input/output error), write_g1 scsi sendcmd: no error
CDB: 2A 00 00 00 00 00 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0A 2A 00 00 80 30 05 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x30 Qual 0x05 (cannot write medium - incompatible format)
Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.002s timeout 200s
/usr/bin/wodim: A write error occured.
/usr/bin/wodim: Please properly read the error message above.
write track data: error after 0 bytes
Writing time: 23.826s
Average write speed 174.0x.
Fixating...
WARNING: Some drives don't like fixation in dummy mode.
Fixating time: 0.004s
cdrecord command:
-----------------------
/usr/bin/wodim -v gracetime=2 dev=1,0,0 speed=16 -dao -dummy
driveropts=burnfree -eject -data -tsize=310363s -
mkisofs
-----------------------
310363
I: -input-charset not specified, using utf-8 (detected in locale settings)
0.16% done, estimate finish Sat Mar 15 07:41:53 2008
0.32% done, estimate finish Sat Mar 15 07:41:53 2008
0.48% done, estimate finish Sat Mar 15 07:41:53 2008
0.65% done, estimate finish Sat Mar 15 07:41:53 2008
0.81% done, estimate finish Sat Mar 15 07:41:53 2008
0.97% done, estimate finish Sat Mar 15 07:41:53 2008
1.13% done, estimate finish Sat Mar 15 07:43:21 2008
1.29% done, estimate finish Sat Mar 15 07:43:10 2008
1.45% done, estimate finish Sat Mar 15 07:43:01 2008
1.61% done, estimate finish Sat Mar 15 07:42:54 2008
1.77% done, estimate finish Sat Mar 15 07:42:49 2008
mkisofs command:
-----------------------
/usr/bin/genisoimage -gui -graft-points -volid Musik -volset -appid K3B
THE CD KREATOR (C) 1998-2005 SEBASTIAN TRUEG AND THE K3B TEAM -publisher
-preparer -sysid LINUX -volset-size 1 -volset-seqno 1 -sort
/tmp/kde-takeda/k3bjowSsa.tmp -rational-rock -hide-list
/tmp/kde-takeda/k3bgAfPeb.tmp -joliet -hide-joliet-list
/tmp/kde-takeda/k3bNCGLec.tmp -full-iso9660-filenames -iso-level 2
-path-list /tmp/kde-takeda/k3blXXp0a.tmp
Reply to: