Re: DVD Laufwerk auslesen
hdparm ist ganz ok, aber das (fuer mich)
wichtigste fehlt, naemlich welche rev das laufwerk
hat: a, b oder c.
hast du noch eine andere idee?
hdparm -I /dev/hdc
/dev/hdc:
ATAPI CD-ROM, with removable media
Model Number: TOSHIBA DVD-ROM SD-M1612
Serial Number:
Firmware Revision: 1004
Standards:
Used: ATAPI for CD-ROMs, SFF-8020i, r2.5
Supported: CD-ROM ATAPI-2
Configuration:
DRQ response: 50us.
Packet size: 12 bytes
Capabilities:
LBA, IORDY(can be disabled)
Buffer size: 512.0kB
DMA: sdma0 sdma1 sdma2 mdma0 mdma1 mdma2
udma0 udma1 *udma2
Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=120ns
IORDY flow control=120ns
HW reset results:
CBLID- below Vih
Device num = 0
Hallo Lucas,
> ich moechte verschiedene informationen von einem
> toshiba SD-m1612 auslesen, u.a. welche rev. es hat
> (revA, revB oder revC).
Abhängig davon welche Informationen Dich genau
interessieren könnten
Dir folgende Programme helfen (alles Konsolentools)
IDE:
hdparm -i /dev/hdX
SCSI:
scsiinfo -a /dev/scdX
allgemein:
cdrecord -scanbus und dann cdrecord dev=0,1,0
-v -checkdrive
nette Grüße
Frank
This message was sent from the free private e-mail service by easy.com, the portal site owned by Stelios and the easyGroup. This email service is available to all members of the public to use for personal reasons only. Not all subscribers to this e-mail service are representatives of an easyGroup company.
Reply to: