Bug#327827: sym53c8xx: Domain Validation Initial Inquiry Failed
Package: linux-image-2.6.12-1-k7
Version: 2.6.12-6
Severity: normal
-- System Information:
Debian Release: testing/unstable
APT prefers unstable
APT policy: (990, 'unstable'), (500, 'stable')
Architecture: i386 (i686)
Shell: /bin/sh linked to /bin/bash
Kernel: Linux 2.6.12-1-k7
Locale: LANG=de_DE.UTF-8, LC_CTYPE=de_DE.UTF-8 (charmap=UTF-8)
Versions of packages linux-image-2.6.12-1-k7 depends on:
ii coreutils [fileutils] 5.2.1-2.1 The GNU core utilities
ii initrd-tools 0.1.82 tools to create initrd image for p
ii module-init-tools 3.2-pre8-1 tools for managing Linux kernel mo
linux-image-2.6.12-1-k7 recommends no packages.
-- no debconf information
Last time my Mustek MFS-6000CX Scanner worked with this driver was
kernel 2.4.27 since then I could use both as a door stop.
Here's logging of output I get when inserting the module:
---8<---
sym0: <810> rev 0x2 at pci 0000:00:0b.0 irq 193
sym0: No NVRAM, ID 7, Fast-10, SE, parity checking
sym0: open drain IRQ line driver
sym0: using NCR-generic firmware.
sym0: initial SCNTL3/DMODE/DCNTL/CTEST3/4/5 = (hex) 00/00/00/00/00/00
sym0: final SCNTL3/DMODE/DCNTL/CTEST3/4/5 = (hex) 03/c8/00/00/08/00
sym0: SCSI BUS has been reset.
sym0: command processing suspended for 3 seconds
scsi3 : sym-2.2.0
sym0: command processing resumed
Vendor: MUSTEK�� Model: MFS-06000CX����� Rev: 4.05
Type: Scanner ANSI SCSI revision: 00
target3:0:1: Beginning Domain Validation
3:0:1:0: phase change 6-7 9@068533a0 resid=8.
3:0:1:0: COMMAND FAILED (2 ff 0).
target3:0:1: Domain Validation Initial Inquiry Failed
target3:0:1: Ending Domain Validation
Attached scsi generic sg0 at scsi3, channel 0, id 1, lun 0, type 6
3:0:1:1: COMMAND FAILED (1 ff 0).
3:0:1:1: COMMAND FAILED (1 ff 0).
3:0:1:1: COMMAND FAILED (1 ff 0).
--->8---
Reply to: