HP LaserJet 6P su porta parallela
Un saluto a tutta la lista!
Ho appena installato Wheezy su di un PC al lavoro e non riesco a far
funzionare la Laserjet collegata via porta parallela.
Quando faccio un
lspci -vv
[...]
03:00.0 Parallel controller: NetMos Technology Device 9900 (prog-if 03
[IEEE1284])
Subsystem: Device a000:2000
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 5
Region 0: I/O ports at dc00 [size=8]
Region 1: I/O ports at d880 [size=8]
Region 2: Memory at feaff000 (32-bit, non-prefetchable)
[size=4K]
Region 5: Memory at feafe000 (32-bit, non-prefetchable)
[size=4K]
Capabilities: <access denied>
vedo che la carta è riconosciuta senza problemi, però in /dev non trovo
né un /lp0 né un /parport: sarà questo il problema?
Il programma che gestisce le stampanti HP, hplip, mi dà:
francesco@desk:~$ hp-setup -i
HP Linux Imaging and Printing System (ver. 3.12.6)
Printer/Fax Setup Utility ver. 9.0
Copyright (c) 2001-14 Hewlett-Packard Development Company, LP
This software comes with ABSOLUTELY NO WARRANTY.
This is free software, and you are welcome to distribute it
under certain conditions. See COPYING file for more details.
(Note: Defaults for each question are maked with a '*'. Press <enter>
to accept the default.)
--------------------------------
| SELECT CONNECTION (I/O) TYPE |
--------------------------------
Num Connection Description
Type
-------- ----------
----------------------------------------------------------
0* usb Universal Serial Bus (USB)
1 net Network/Ethernet/Wireless (direct connection or JetDirect)
2 par Parallel Port (LPT:)
Enter number 0...2 for connection type (q=quit, enter=usb*) ? 2
Using connection type: par
error: No device selected/specified or that supports this functionality.
-----
Cosa mi consigliate di fare (a parte comprate un stampate USB)?
Grazie mille,
Francesco
Reply to: