Package: installation-reports Boot method: USB fob Image version: <Full URL to image you downloaded is best> Date: <Date and time of the install> Machine: Intel DM2800MT 1.86GHz. MiniITX Processor: N2800 Memory: 8G Partitions: <df -Tl will do; the raw partition table is preferred> Filesystem Type 1K-blocks Used Available Use% Mounted on rootfs rootfs 26913012 2894912 22650960 12% / udev devtmpfs 10240 0 10240 0% /dev tmpfs tmpfs 829316 632 828684 1% /run /dev/disk/by-uuid/de261878-4e53-42b9-9b1b-99717755fc68 ext4 26913012 2894912 22650960 12% / tmpfs tmpfs 5120 0 5120 0% /run/lock tmpfs tmpfs 2443000 0 2443000 0% /run/shm Output of lspci -knn (or lspci -nn): 00:00.0 Host bridge [0600]: Intel Corporation Atom Processor D2xxx/N2xxx DRAM Controller [8086:0bf2] (rev 03) 00:02.0 VGA compatible controller [0300]: Intel Corporation Atom Processor D2xxx/N2xxx Integrated Graphics Controller [8086:0be2] (rev 09) 00:1b.0 Audio device [0403]: Intel Corporation NM10/ICH7 Family High Definition Audio Controller [8086:27d8] (rev 02) 00:1c.0 PCI bridge [0604]: Intel Corporation NM10/ICH7 Family PCI Express Port 1 [8086:27d0] (rev 02) 00:1d.0 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB UHCI Controller #1 [8086:27c8] (rev 02) 00:1d.1 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB UHCI Controller #2 [8086:27c9] (rev 02) 00:1d.2 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB UHCI Controller #3 [8086:27ca] (rev 02) 00:1d.3 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB UHCI Controller #4 [8086:27cb] (rev 02) 00:1d.7 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB2 EHCI Controller [8086:27cc] (rev 02) 00:1e.0 PCI bridge [0604]: Intel Corporation 82801 Mobile PCI Bridge [8086:2448] (rev e2) 00:1f.0 ISA bridge [0601]: Intel Corporation NM10 Family LPC Controller [8086:27bc] (rev 02) 00:1f.2 SATA controller [0106]: Intel Corporation NM10/ICH7 Family SATA Controller [AHCI mode] [8086:27c1] (rev 02) 00:1f.3 SMBus [0c05]: Intel Corporation NM10/ICH7 Family SMBus Controller [8086:27da] (rev 02) 01:00.0 Ethernet controller [0200]: Intel Corporation 82574L Gigabit Network Connection [8086:10d3] Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Initial boot: [ O] Detect network card: [ O] Configure network: [ O] Detect CD: [ O] Load installer modules: [ O] Detect hard drives: [ O] Partition hard drives: [ O] Install base system: [ O] Clock/timezone setup: [ O] User/password setup: [ O] Install tasks: [ O] Install boot loader: [ O] Grub Overall install: [ E] Comments/Problems: Display shows grub boot menu, and then nothing. Same problem 64 and 32 bit. This problem did not exist in 7.1, but this could be coincidental as I was using a network repository,so a package could be at fault. The machine is alive as I can ssh into it. |