--- Begin Message ---
Package: installation-reports
Debian-installer-version: pre RC2 and current (10/03) tested
uname -a: Didn't get there
Date: 10/03/2004
Method: CD
Machine: dmesg (from older debian) below, not listed are 2 Adaptec
ASH-1205SA SATA controllers with 3 250GB maxtor SATA disks
Processor: AMD Athlon 900MHz
Memory: 256MB
Root Device: IDE
Root Size/partition table: n/a
Output of lspci and lspci -n: did not get there...
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot worked: [E]
Configure network HW: [ ]
Config network: [ ]
Detect CD: [ ]
Load installer modules: [ ]
Detect hard drives: [ ]
Partition hard drives: [ ]
Create file systems: [ ]
Mount partitions: [ ]
Install base system: [E]
Install boot loader: [ ]
Reboot: [ ]
Comments/Problems:
Trying the default kernel, it hangs fairly soon. First it sticks a long
time at ide_detect, then it hangs terminally at sd_mod.
Using linux26, installation proceeds well at first. However during the
apt configuration (after fixing the known cdrom mountpoint problem)
there are problems adding additional sources. No matter if I select ftp
or http and no matter what mirror, it hangs here:
0% [Waiting for headers]
Network connection is fine (checked with other terminal, can ping
mirrors), and ftp login works too.
Stuck here, please help!
Gerd
Linux version 2.2.20-idepci (herbert@gondolin) (gcc version 2.7.2.3) #1
Sat Apr 20 12:45:19 EST 2002
BIOS-provided physical RAM map:
BIOS-e820: 0009f000 @ 00000000 (usable)
BIOS-e820: 0eef0000 @ 00100000 (usable)
Detected 900065 kHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1795.68 BogoMIPS
Memory: 241368k/245696k available (1164k kernel code, 412k reserved,
2680k data, 72k init)
Dentry hash table entries: 32768 (order 6, 256k)
Buffer cache hash table entries: 262144 (order 8, 1024k)
Page cache hash table entries: 65536 (order 6, 256k)
CPU: L1 I Cache: 64K L1 D Cache: 64K
CPU: L2 Cache: 256K
CPU: AMD Athlon(tm) Processor stepping 02
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
Checking for popad bug... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.35a (19990819) Richard Gooch (rgooch@atnf.csiro.au)
PCI: PCI BIOS revision 2.10 entry at 0xfdb31
PCI: Using configuration type 1
PCI: Probing PCI hardware
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
TCP: Hash tables configured (ehash 262144 bhash 65536)
Starting kswapd v 1.5
vga16fb: initializing
vga16fb: mapped to 0xc00a0000
Console: switching to colour frame buffer device 80x30
fb0: VGA16 VGA frame buffer device
Detected PS/2 Mouse Port.
Serial driver version 4.27 with HUB-6 MANY_PORTS MULTIPORT SHARE_IRQ
enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
pty: 256 Unix98 ptys configured
RAM disk driver initialized: 16 RAM disks of 4096K size
loop: registered device at major 7
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xff00-0xff07, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xff08-0xff0f, BIOS settings: hdc:DMA, hdd:pio
hda: ST330013A, ATA DISK drive
hdc: Hewlett-Packard CD-Writer Plus 9100, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: ST330013A, 28629MB w/2048kB Cache, CHS=3649/255/63
hdc: ATAPI 32X CD-ROM CD-R/RW drive, 4096kB Cache
Uniform CD-ROM driver Revision: 3.11
floppy0: no floppy controllers found
3c59x.c 18Feb01 Donald Becker and others
http://www.scyld.com/network/vortex.html
pcnet32.c: PCI bios is present, checking for devices...
eepro100.c:v1.09j-t 9/29/99 Donald Becker
http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
eepro100.c: $Revision: 1.20.2.10 $ 2000/05/31 Modified by Andrey V.
Savochkin <saw@saw.sw.com.sg> and others
eepro100.c: VA Linux custom, Dragan Stancevic <visitor@valinux.com>
2000/11/15
eth0: Intel PCI EtherExpress Pro100 82557, 00:02:B3:87:FE:A0, IRQ 12.
Board assembly 751767-004, Physical connectors present: RJ45
Primary interface chip i82555 PHY #1.
Secondary interface chip i82555.
General self-test: passed.
Serial sub-system self-test: passed.
Internal registers self-test: passed.
ROM checksum self-test: passed (0x3258698e).
eepro100.c:v1.09j-t 9/29/99 Donald Becker
http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
eepro100.c: $Revision: 1.20.2.10 $ 2000/05/31 Modified by Andrey V.
Savochkin <saw@saw.sw.com.sg> and others
eepro100.c: VA Linux custom, Dragan Stancevic <visitor@valinux.com>
2000/11/15
via-rhine.c:v1.08b-LK1.0.1 12/14/2000 Written by Donald Becker
http://www.scyld.com/network/via-rhine.html
Partition check:
hda: hda1 hda2 hda3 hda4
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.13)
apm: disabled on user request.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 72k freed
Adding Swap: 498004k swap-space (priority -1)
--- End Message ---
--- Begin Message ---
We are closing this installation report for one of the following
reasons:
- it was reported with a pre-lenny version of Debian
Installer.
- indications in the installation report give the feeling that
the reported problem waslying in another software, unrelated to
D-I, which we can't easily identify.
- indications in the installation report suggest that it may have been
fixed in a more recent version of a D-I component
- it was successful and we forgot closing it..:-)
- it has no information we consider useful
The D-I team is currently in the process of cleaning out the old spool
of installation reports that haven't bene processed yet.
In case you think that the problem you reported has chances to be
still present, please reiterate your installation test with
a more recent image of D-I, if you're in position of doing this.
You'll find daily builds at
http://www.debian.org/devel/debian-installer. We recommend you choose
the netboot image, in the "daily builds section", then choose to
install "squeeze" when prompted.
If some problems are found, please report them with a new bug sent
against installation-reports.
Many thanks for your understanding and your help improving Debian,
past and present.
--- End Message ---