Bug#485694: Submitting Installation Reports
Package: installation-reports
Boot method:CD
Image version: debian-LennyBeta2-i386-CD-1.iso
Date: 2008/06/11
Machine: Assembled
Processor: AMD Athlon(tm) 64 X2 Dual Core Processor 4000+
Memory:DDR2 2G
Partitions: <df -Tl will do; the raw partition table is preferred>
Sorry not available, because the installation was failed, but I followed the basic partition steps given by Debian installer.
HDD: Maxtor DiamondMax Plus9 80G ATA/133
Output of lspci -nn and lspci -vnn:
>From Ubuntu
00:00.0 RAM memory [0500]: nVidia Corporation Unknown device [10de:0547] (rev a2)
00:01.0 ISA bridge [0601]: nVidia Corporation Unknown device [10de:0548] (rev a2)
00:01.1 SMBus [0c05]: nVidia Corporation Unknown device [10de:0542] (rev a2)
00:01.2 RAM memory [0500]: nVidia Corporation Unknown device [10de:0541] (rev a2)
00:02.0 USB Controller [0c03]: nVidia Corporation Unknown device [10de:055e] (rev a2)
00:02.1 USB Controller [0c03]: nVidia Corporation Unknown device [10de:055f] (rev a2)
00:04.0 USB Controller [0c03]: nVidia Corporation Unknown device [10de:055e] (rev a2)
00:04.1 USB Controller [0c03]: nVidia Corporation Unknown device [10de:055f] (rev a2)
00:06.0 IDE interface [0101]: nVidia Corporation Unknown device [10de:0560] (rev a1)
00:07.0 Audio device [0403]: nVidia Corporation MCP67 High Definition Audio [10de:055c] (rev a1)
00:08.0 PCI bridge [0604]: nVidia Corporation Unknown device [10de:0561] (rev a2)
00:09.0 IDE interface [0101]: nVidia Corporation Unknown device [10de:0550] (rev a2)
00:0a.0 Ethernet controller [0200]: nVidia Corporation Unknown device [10de:054c] (rev a2)
00:12.0 VGA compatible controller [0300]: nVidia Corporation Unknown device [10de:053e] (rev a2)
00:18.0 Host bridge [0600]: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] HyperTransport Technology Configuration [1022:1100]
00:18.1 Host bridge [0600]: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Address Map [1022:1101]
00:18.2 Host bridge [0600]: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] DRAM Controller [1022:1102]
00:18.3 Host bridge [0600]: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Miscellaneous Control [1022:1103]
01:0e.0 FireWire (IEEE 1394) [0c00]: Texas Instruments TSB43AB23 IEEE-1394a-2000 Controller (PHY/Link) [104c:8024]
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [O]
Detect network card: [O]
Configure network: [O]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Install base system: [O]
Clock/timezone setup: [O]
User/password setup: [O]
Install tasks: [E]
Install boot loader: [O]
Overall install: [E]
Comments/Problems:
Install tasks does not work properly. The task could start, but there was nothing installed (not even one package).
The task just said "Failed". Then I tried to start the task manually again, but failed again.
Reply to: