--- Begin Message ---
- To: Debian Bug Tracking System <submit@bugs.debian.org>
- Subject: installation-reports: ifconfig has no MAC-address changing support
- From: Roland Ambrosch <monotonous@gmx.at>
- Date: Thu, 05 Aug 2004 12:20:44 +0200
- Message-id: <E1BsfMa-0000RP-2R@localhost.localdomain>
Package: installation-reports
Severity: wishlist
Debian-installer-version: 20040802 http://cdimage.debian.org/pub/cdimage-testing/daily/i386/20040802/
uname -a: Linux goop 2.6.7 #1 Tue Aug 3 16:21:49 CEST 2004 i686 GNU/Linux
Date: 20040803 12:00am (GTC+2)
Method: network install with a minimum CD from CD; no proxy but direct access using LAN; mirror ftp.at.debian.org
Machine: desktop PC with an AMD 2400 and 512 RAM; self assembled
Processor: AMD Athlon(tm) XP 2400+
Memory: 512 MB
Root Device: IDE Seagate ST380011A
Root Size/partition table:
/dev/hdc1 root-partition 20 Gb mounted as /; ext3
/dev/hdc6 swap-partition 512 MB
Output of lspci:
0000:00:00.0 Host bridge: VIA Technologies, Inc. VT8366/A/7 [Apollo KT266/A/333]
0000:00:01.0 PCI bridge: VIA Technologies, Inc. VT8366/A/7 [Apollo KT266/A/333 AGP]
0000:00:07.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
0000:00:0a.0 SCSI storage controller: Adaptec AHA-7850 (rev 03)
0000:00:10.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 80)
0000:00:10.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 80)
0000:00:10.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 80)
0000:00:10.3 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 82)
0000:00:11.0 ISA bridge: VIA Technologies, Inc. VT8235 ISA Bridge
0000:00:11.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06)
0000:00:11.5 Multimedia audio controller: VIA Technologies, Inc. VT8233/A/8235/8237 AC97 Audio Controller (rev 50)
0000:01:00.0 VGA compatible controller: nVidia Corporation NV31 [GeForce FX 5600] (rev a1)
Base System Installation Checklist:
Initial boot worked: [O]
Configure network HW: [O]
Config network: [E]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Create file systems: [O]
Mount partitions: [O]
Install base system: [O]
Install boot loader: [O]
Reboot: [O]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
Installation worked really fine, except that I first had to install only the basic packages, until I bootet the first time in my new system to change the MAC-address of my NIC to the one my provider knows to get network access with an IP I get through DHCP. It would be great if there would be a ifconfig version in the first bootup, which allows me to change the MAC-address when the module got loaded the first time. The command I use is "ifconfig eth0 hw ether <MAC-address>
-- System Information:
Debian Release: 3.1
APT prefers testing
APT policy: (500, 'testing')
Architecture: i386 (i686)
Kernel: Linux 2.6.7
Locale: LANG=C, LC_CTYPE=C
--- End Message ---
--- Begin Message ---
- To: 263596-done@bugs.debian.org
- Subject: busybox-cvs-udeb has been removed from Debian, closing #263596
- From: Marco Rodrigues <gothicx@sapo.pt>
- Date: Fri, 6 Jun 2008 22:35:51 +0100
- Message-id: <200806062135.m56LZpFE009378@kmos.homeip.net>
Version: 20040623-1+rm
The busybox-cvs-udeb package has been removed from Debian testing, unstable and
experimental, so I am now closing the bugs that were still opened
against it.
For more information about this package's removal, read
http://bugs.debian.org/331153 . That bug might give the reasons why
this package was removed, and suggestions of possible replacements.
Don't hesitate to reply to this mail if you have any question.
Thank you for your contribution to Debian.
--
Marco Rodrigues
http://Marco.Tondela.org
--- End Message ---