Bug#449029: unknown network card
retitle 449029 unknown network card
tags 449029 moreinfo
stop
Op 02-11-2007 om 22:24 schreef Adachi Junichi:
Machine: Main Board:K8M800-MLVF Rev.B (via k8m800/ via VT8237)
Output of lspci -nn and lspci -vnn:
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [O]
Detect network card: [E]
That is reason why I retitled the bug report to "unknown network card"
Configure network: [ ]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
I don't known / I can't see
why installation is not continued after detecting the Hard Disk.
I aborted it.
I installed and configured testing(Lenny)-netinst(13 Aug 2007),
and 4.0Etch to same K8M800-MLVF machines.
I want take pictures and write installation how-to.
The installer detected network card, never missed it.
But this time testing(Lenny)-CD-1(15 Oct 2007) can not detect.
So I wrote report.
I tried testing(Lenny)-CD-1(29 Oct 2007) too.
It can't detect network card too. And in addition,
the installer said,
"No kernel modules were found.
This probably is due to a mismatch between the
kernel used by this version of the installer and
the kernel version available in the archive..."
Please provide more information.
Things important to tell:
* Did the install from augustus had a working network card?
Yes, the net work card is on board, exactly same.
* the output of
lspci -nn | grep Ethernet
00:12.0 Ethernet controller [0200]: VIA Technologies,
Inc. VT6102 [Rhine-II] [1106:3065] (rev 78)
(it is same to working Lenny)
* Why the install was aborted after hard disk detection.
I tried several times to detect network card.
I got a menu to try again and shell,
I thought may be many trouble to continue without network,
so I quit installation.
--
ADACHI Junichi
adachi@seiai.ed.jp
http://seiai.ed.jp
Reply to: