[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#395886: marked as done ()

Your message dated Wed, 01 Nov 2006 07:27:20 +0100
with message-id <200611010727.20727.elendil@planet.nl>
and subject line Bug#395886:
has caused the attached Bug report to be marked as done.

This means that you claim that the problem has been dealt with.
If this is not the case it is now your responsibility to reopen the
Bug report if necessary, and/or fix the problem forthwith.

(NB: If you are a system administrator and have no idea what I am
talking about this indicates a serious mail system misconfiguration
somewhere.  Please contact me immediately.)

Debian bug tracking system administrator
(administrator, Debian Bugs database)
--- Begin Message --- 
Package: installation-reports

Boot method: <How did you boot the installer? CD? floppy? network?>
Image version: <Fill in date and from where you got the image>
Date: <Date and time of the install>

Machine: <Description of machine (eg, IBM Thinkpad R32)>
Processor:
Memory:
Partitions: <df -Tl will do; the raw partition table is preferred>

Output of lspci and lspci -n:

Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Initial boot worked:    [O]
Configure network HW:   [E]
Config network:         [O]
Detect CD:              [O]
Load installer modules: [O]
Detect hard drives:     [O]
Partition hard drives:  [O]
Create file systems:    [O]
Mount partitions:       [O]
Install base system:    [O]
Install boot loader:    [O]
Reboot:                 [O]

Comments/Problems:

Multiple network card (Built in on a MSI K8N Neo4) detection is confused. The same card is detected as eth0, eth1 or eth2
upon subsequent install trials.

--- End Message ---
--- Begin Message --- 
On Saturday 28 October 2006 14:20, Giorgio Pioda wrote:
> Comments/Problems:
> Multiple network card (Built in on a MSI K8N Neo4) detection is
> confused. The same card is detected as eth0, eth1 or eth2 upon
> subsequent install trials.

Yes, that can happen. This is a "feature" of the way modern kernels detect 
devices and not something we can influence in the installer. Basically 
the kernel probes all hardware in parallel and this can lead to different 
results on different boots.

As your installation was successful, I'm closing your report. Thank you 
very much for submitting it.

Cheers,
FJP

--- End Message ---
Reply to: