DAC960 and SRM trouble
Hello -
I had a DAC960P in my AS1200 and it was working fine, but rather slow.
I found what I believe is a DAC960PD-Ultra (d040393 - the x-reference
just says PD - is this ultra-wide?) in hopes that it
would be faster in utilizing my ultra-wide drives. It has the 3.x
firmware version (latest 2-chip firmware). Well, I put it in, copied
the config from the other controller and ran a parity check just to make
sure. I then tried to boot from it (I was booting from the old one
without problem) but srm said "no controller found for device DRA0. I
did a sh dev and it listed something like:
dra0.x.x.x DRA0 3member raid 5
dra1.x.x.x DRA1 3 member Raid 0
but it wont boot from it.
Any ideas? or is this two chip firware not supported in srm?
Thank's,
Mike Campbell
p.s. - btw, the thing works - i have a spare drive which i booted from
with root=/dev/rd/c0d0p2 no problem
--
To announce that there must be no criticism of the president, or that we are to stand by the president, right or wrong, is not only unpatriotic and servile, but is morally treasonable to the American public.
-- Theodore Roosevelt
Reply to: