[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: Miata MX, can't boot past 2.4.18



> 
> I run stock 2.4.21 on my PWS433au. I boot on scsi with SRM+aboot, but the
> ide cd-rom works ok on the CMD646. My config is at
> http://www.hut.fi/u/jlinnosa/alpha/config-2.4.21 if you want to take a
> look.
> 
> 
> Jaska
> 

Hi,

It should be noted that my Miata is purely IDE based.  there are no scsi interfaces in
the system.  boot is dka0, a 20gb IDE drive, connected to primary/master of the CMD646
a 15gb hdd is connected primary/slave on the CMD646 (dka100)
there is the 12x toshiba ide cdrom connected to the secondary/slave port as dkb0

and the drive i'm trying to get working is a 80gb seagate bara IV behind a CMD680

I modified my .config to reflect the CMD640 config flags that you had set in your .config
but hit a snare, for some reason i now need an initrd.img yet didn't set the --initrd
flag on make-kpkg.  I used the following command to compile the kernel:
make-kpkg --revision 2 kernel_image

I then went and installed kernel-image-2.4.20-3 again to try as it was the closest that
any other kernel has got so far this is the error message i got.

fyi
eth0 00:03.0 Ethernet controller: Digital Equipment Corporation DECchip 21142/43 (rev 30)
eth1 01:08.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
eth2 01:0a.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)

eth0 is connected to an alcatel speed touch home adsl bridge/modem
eth1 is connected to a 100meg switch
eth2 has no ethernet connection in it.

eth2: (107) System Error occured (1)
eth2: (107) System Error occured (1)
eth2: (107) System Error occured (1)
eth0: Too much work at interrupt, IntrStatus=0x0001.
eth0: Too much work at interrupt, IntrStatus=0x0001.
eth0: Too much work at interrupt, IntrStatus=0x0001.
eth2: (107) System Error occured (1)
eth2: (108) System Error occured (1)
eth2: (109) System Error occured (1)
[scrolls rapidly]

then after a few thousand lines of the above i get the following goop

(6 ( E (deh2uysethcS3r24)r(dem2urseo) <o251E ettcc<or11) (dehcSy>eoc <3r41Eretthcuy> 0) ()
r8 ( Erettc S3> 6)
edeh2Sy> oc <3r75)
rd m2uysetc S3> 4)
r96(1E edem2:rsteh2uyseoc ru<3201Sm r r1)et25sEroe)e5ercc (32:69ysrure): 7ysErocd <321terd
 7yoru(3232Srod
t(9sE oe)
t(3sE oed
 3moc  (3sE (32:2Sy E <h1)E re)
[ random strings continue until a hard power reset]


~Nick
-----
Every cloud has a silver lining (except for the mushroom shaped ones, which have a lining of Iridium & Strontium 90)



Reply to: