[gopher] Re: gopher and IPv6
Am Sonntag 18 Januar 2009 12:52:00 schrieb Jeroen Schot:
> On Jan 17, 2009, at 11:34 PM, Cameron Kaiser wrote:
> >>>> after some tries to enable public access to my home gopher reliably
> >>>> (read: without NAT and other evil stuff), i'd like to set up an
> >>>> IPv6
> >>>> gopher. But: i haven't yet managed to have any gopher daemon bind
> >>>> to an
> >>>> IPv6 port yet. What i tried so far is: GoFish and pygopherd.
> >>>> Anyone did this before? Or is there a gopher server that runs from
> >>>> xinetd? Have until now only tried standalone servers (the two named
> >>>> above).
> >>>
> >>> bucktooth will happily run in either environment. I haven't really
> >>> tested
> >>> it in IPv6 however (grumbles at upstream).
> >>
> >> Well, as far as i can tell right now, bucktooth happily serves
> >> gopher over
> >> IPv6 both on IPv6-only machines as well as on dual-stack boxes.
> >> Configuration
> >> of xinetd is a tad, umm, unintuitive as i had to find out.
> >
> > Does it properly report source addresses in the log file? I am
> > encouraged
> > to hear that it operates, however.
> >
> > Once my ISP offers me IPv6, I intend to do more testing with it.
>
> I run bucktooth (0.2.6) from openbsd-inetd dual-stack. I just checked,
> and ipv6 source addresses are *not* correct: It always shows 0.0.0.0.
> Maybe I have some time next week to see if I can solve this.
>
Same here with shown IPv6 adresses being 0.0.0.0. :-/
greets,
Florian
Reply to: