network question
Greetings all netsperts;
I've purchased a new 3d printer which is factory equipt with klipper.
It has zero docs with it, just a very short quick start guide which
totally disregards any questions a new user might have.
It has a cat-5 connector and a socket for a usb key, which according to
what I've read on their web page is for updating the firmware.
I have plugged in a supplied cat-5 jumper into a port of the local
switch serving that room and now need to find it on my local net IF it
has a ping responder.
So the questions are:
What do I need to change in my network config on this machine so I can
ping all 65536 address of the 192.168 block of ipv4 address?
Will changing the CIDR, presently /24 to /16 be sufficient?
Cheers, Gene Heskett.
--
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author, 1940)
If we desire respect for the law, we must first make the law respectable.
- Louis D. Brandeis
Reply to: