Re: biqu bx 3d printer ??
On Wednesday, December 22, 2021 6:12:19 AM EST didier gaumet wrote:
> Le mercredi 22 décembre 2021 à 04:36 -0500, gene heskett a écrit :
>
> [...]
>
> > But cura isn't finding this
> > biqu bx.
> >
> > What utility could adjust the baud and endianess of this tty_ACM0?
>
> [...]
>
> Disclaimer: I have never used a 3D printer, and my knowledge of com
> port setup is limited to dial-in modems as a user, back in the day...
>
> I would imagine that there is a way in Cura to add and setup a new
> printer with a particular com port at the adequate speed. This is
> appears to be the case in Repetier-host via a GUI.
>
> And perhaps, if you manage to tell your slicer what com port is to be
> used, you can manage this com port the old way:
> https://tldp.org/HOWTO/Serial-HOWTO.html
>
I was not aware of that tutorial, thank you very much.
Cheers, Gene Heskett.
--
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author, 1940)
If we desire respect for the law, we must first make the law respectable.
- Louis D. Brandeis
Genes Web page <http://geneslinuxbox.net:6309/gene>
Reply to: