[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: Ipv6, but no Ipv4 after reboot

On 12/9/20 4:54 PM, Dominique Dumont wrote:
> Hi
> I've run in a weird problem. After a reboot, only Ipv6 address is setup on my 
> wired network card.
> The workaround is fairly simple: disconnect and reconnect with network 
> manager. Note that Ipv4 is brought up after suspend/resume
> Still, this is cumbersome. I've found no obvious problems in the logs. 
> Where should I look to investigate this problem ?  


try to edit the connection parameters in network manager and check the
following checkbox "IPv4 is required for this connection" on "IPv4" tab.

Kind regards

Reply to: