Re: JVC camera and Hauppauge PVR-150 framegrabber. Was: Re: MTI camera ...
On Wed, Mar 22, 2017 at 05:35:43PM -0700, peter@easthope.ca wrote:
> With a manual setting of the device path and ID, the V4L2 Test Bench
> produced this image from the JVC camera on the microscope.
> http://easthope.ca/JVCtoPVR150screen.jpg
>
> Setting the device in the Test Bench each time it is opened becomes
> tedious and no /etc/*v4l* exists. Can the default conifiguration be
> adjusted permanently without recompiling? How?
>
> Although too dark, the image from the microscope slide is faintly
> visible. The upper half of the image is on the bottom of the screen
> and the lower half is at the top. On a VCR I might try adjusting
> vertical sync. Is there an equilent in the Test Bench?
The linux-media list at majordomo@vger.kernel.org might be your
best resource, here.
-dsr-
Reply to: