Re: how to specify kernel parameter "memmap="
On 1/8/14, Ralf Mardorf <ralf.mardorf@alice-dsl.net> wrote:
> On Mon, 2014-01-06 at 07:48 -0500, Long Wind wrote:
>> knoppix CD doesn't seem to be able to boot
> On Thu, 2014-01-09 at 09:23 +0800, Long Wind wrote:
>> I'v try Knoppix, it can't run, I make no progress
>
> What does it mean? You put the Knoppix CD/DVD into the drive and then
> doesn't happen anything? Or does it start to boot and then doesn't
> finish the boot process? If it does start booting, at what point does it
> stop booting? Linux does show messages during the boot process and we
> ask you several times to post those messages. We also told you what to
> do, if you should see a picture instead of messages, then you need to
> push the Esc-key or one of the F-Keys. Try one key after the other until
> you see messages.
>
I have attached a photo of screen in email
the photo isn't very clear, hopefully you can see it
> You could start troubleshooting by posting at least the last complete
> message before booting stops.
>
> On Thu, 2014-01-09 at 09:33 +0800, Long Wind wrote:
>> today I plug the disk with woody to a P4/1.6G PC
>> it can't boot though it can boot a P4/2.9G PC
>
> You put another CPU into the same motherboard? You used another PC with
> another motherboard with another chip set, graphics etc.?
>
no, I don't change CPU, it's another motherboard
>> error msg are mainly about CPU
>
> Is it a guessing game? Post the original complete error messages you
> get. The "mainly about CPU" and the few others too.
>
>
I am not sure whether error msg is logged
I am too tired of the problem
Reply to: