[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: Graphics corruption with Radeon X1270 (RS690M)



On Mon, 28 Nov 2011 02:50:52 -0500, Carl wrote in message 
<[🔎] 20111128075052.GA13420@panix.com>:

> On Mon, Nov 28, 2011 at 02:01:15AM +0100, Arnt Karlsen wrote:
> 
> > ..run 'dpkg-reconfigure locales' and pick or verify you have picked
> > all your relevant UTF-8 locales, you may want to toss out your
> > "ISO-8859-*" locales.  Next, run aptitude and trawl 'n haul in 
> > "all" UTF-8 fonts, and make those your apps, wm, DE etc defaults.

..duh, "man xrefresh" should give you another set of fix ideas.

> The only installed locale is en-us.UTF-8.
> 
> I have no earthly use for any of the ISO-8859 fonts shown by
> aptitude--they're for languages I do not use.
> 
> > ..and 'xrandr --verbose' says?
> 
> Screen 0: minimum 320 x 200, current 1366 x 768, maximum 8192 x 8192
> VGA-0 disconnected (normal left inverted right x axis y axis)
>         Identifier: 0x41
>         Timestamp:  22915
>         Subpixel:   no subpixels
>         Clones:    
>         CRTCs:      0 1
>         Transform:  1.000000 0.000000 0.000000
>                     0.000000 1.000000 0.000000
>                     0.000000 0.000000 1.000000
>                    filter: 
>         load detection: 1 (0x00000001)  range:  (0,1)
> LVDS connected 1366x768+0+0 (0x43) normal (normal left inverted right
> x axis y axis) 256mm x 144mm
>         Identifier: 0x42
>         Timestamp:  22915
>         Subpixel:   horizontal rgb
>         Gamma:      1.0:1.0:1.0
>         Brightness: 1.0
>         Clones:    
>         CRTC:       0
>         CRTCs:      0 1
>         Transform:  1.000000 0.000000 0.000000
>                     0.000000 1.000000 0.000000
>                     0.000000 0.000000 1.000000
>                    filter: 
>         EDID:
>                 00ffffffffffff000daf001100000000
>                 0913010380190e780acf459059579529
>                 1f505400000001010101010101010101
>                 0101010101019c19562a50000830070e
>                 1300009010000018000000fe004e3131
>                 3642362d4c30320a2020000000fe0043
>                 4d4f0a202020202020202020000000fe
>                 004e31313642362d4c30320a20200065
>         scaling mode:   Full
>                 supported: None         Full         Center
> Full aspect 1366x768 (0x43)   65.6MHz -HSync -VSync *current
> +preferred h: width  1366 start 1373 end 1387 total 1408 skew    0
> clock   46.6KHz v: height  768 start  769 end  772 total
> 776           clock   60.0Hz 

..ok, try one of the resolutions below and see if one of those 
fixes the "overwriting", if that works, you should be able to 
make a slightly slower 1366x768 modeline work, backing off to 
say 46.5kHz and 59.9Hz or some such.  

..do you have grandr installed?  The cli way:
http://wiki.debian.org/XStrikeForce/HowToRandR12

..to make new 1366x768 modelines the _old_ way, install videogen
and have fun tweaking your new modelines. ;o)

..dirty search line: 'apt-cache search --full modelines |less'

> 1280x720 (0x44)   74.5MHz -HSync +VSync
>         h: width  1280 start 1344 end 1472 total 1664 skew    0
> clock   44.8KHz v: height  720 start  723 end  728 total
> 748           clock   59.9Hz 1152x768 (0x45)   71.8MHz -HSync +VSync
>         h: width  1152 start 1216 end 1328 total 1504 skew    0
> clock   47.7KHz v: height  768 start  771 end  781 total
> 798           clock   59.8Hz 1024x768 (0x46)   63.5MHz -HSync +VSync
>         h: width  1024 start 1072 end 1176 total 1328 skew    0
> clock   47.8KHz v: height  768 start  771 end  775 total
> 798           clock   59.9Hz 800x600 (0x47)   38.2MHz -HSync +VSync
>         h: width   800 start  832 end  912 total 1024 skew    0
> clock   37.4KHz v: height  600 start  603 end  607 total
> 624           clock   59.9Hz 848x480 (0x48)   31.5MHz -HSync +VSync
>         h: width   848 start  872 end  952 total 1056 skew    0
> clock   29.8KHz v: height  480 start  483 end  493 total
> 500           clock   59.7Hz 720x480 (0x49)   26.8MHz -HSync +VSync
>         h: width   720 start  744 end  808 total  896 skew    0
> clock   29.9KHz v: height  480 start  483 end  493 total
> 500           clock   59.7Hz 640x480 (0x4a)   23.8MHz -HSync +VSync
>         h: width   640 start  664 end  720 total  800 skew    0
> clock   29.7KHz v: height  480 start  483 end  487 total
> 500           clock   59.4Hz


-- 
..med vennlig hilsen = with Kind Regards from Arnt Karlsen
...with a number of polar bear hunters in his ancestry...
  Scenarios always come in sets of three: 
  best case, worst case, and just in case.


Reply to: