[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: problem with module loading in etch



Thanks!
I'll try your solutions later on.

On Fri, Mar 27, 2009 at 4:53 PM, Alex Samad <alex@samad.com.au> wrote:
> On Fri, Mar 27, 2009 at 04:25:40PM -0400, Long Wind wrote:
>> I have a bttv card
>> etch loads driver for it during booting
>> but etch does not use correct options
>> so I have to use commands below:
>>
>> rmmod bttv
>> modprobe bttv card=8
>>
>> I add "bttv card=8" to /etc/modules
>> but it does not help.
>>
>> My question is how to help etch use correct options so that I needn't
>> enter the 2 commands every time I boot etch.
>
>
> I would put something into /etc/modprobe.d/bttv like
> options bttv card=8
>
> then do a update-initramfs
>
>>
>>
>
> --
> "It's unacceptable to think that there's any kind of comparison between the behavior of the United States of America and the action of Islamic extremists who kill innocent women and children to achieve an objective."
>
>        - George W. Bush
> 09/15/2006
> Washington, DC
> White House Press Conference
>
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v1.4.9 (GNU/Linux)
>
> iEYEARECAAYFAknNPMAACgkQkZz88chpJ2ODiwCfYqCey05AEVj+vrcNDDC5LlfV
> evYAoLuyfJOJ8jXwly054sD8g0lgOzdZ
> =tPyr
> -----END PGP SIGNATURE-----
>
>


Reply to: