Re: TTY programming
On Tue, Dec 02, 2008 at 11:34:05AM +0200, David Baron wrote:
> I have seen loads of postings but no real answer to this:
> I write() a command to the modem
> I read() to try to get a response, i.e. OK or if the command is a dial, BUSY
> or such.
> I do not get anything.
> The commands, dialing, all seem successful and the application works. I simply
> cannot report any status.
> Any ideas?
Many modems have a quiet or echo mode that can turn on/off output of
status messages, e.g., ATe0 or similar.