David Jantzen wrote:
Hey All, I installed some upgrades yesterday to my testing/unstable installation. The relevant packages changed (as far as I understand) were: fglrx-control fglrx-driver fglrx-kernel-src Apt uninstalled my kernel module compiled for 3D support, and so Irecompiled and installed again from the new source withm-a a-i fglrx After reboot, my only usable resolution (1600x1050) is unavailable. Even the Catalyst control center believes it's not there. Xorg.conf was unchanged, so I doubt that was it. Any ideas on the cause? Suggestions? I can certainly live without 3D support if the solution is to revert to the kernel module from Apt, although I'd need some direction on how to do that. Thanks! David
Hello, Davidin case you use amd64 branch can you show your xorg.conf file, because my X did't start after installing fglrx-driver-8.44.3-1.
It stopped with following error: (II) fglrx(0): Supported Future Video Modes: (II) fglrx(0): #0: hsize: 1280 vsize 720 refresh: 60 vid: 49281 (II) fglrx(0): #1: hsize: 1280 vsize 960 refresh: 60 vid: 16513 (II) fglrx(0): #2: hsize: 1152 vsize 864 refresh: 60 vid: 16497 (II) fglrx(0): #3: hsize: 1280 vsize 1024 refresh: 60 vid: 32897 (II) fglrx(0): #4: hsize: 1440 vsize 900 refresh: 60 vid: 149 (II) fglrx(0): Supported additional Video Mode: (II) fglrx(0): clock: 106.5 MHz Image Size: 410 x 256 mm(II) fglrx(0): h_active: 1440 h_sync: 1520 h_sync_end 1672 h_blank_end 1904 h_border: 0 (II) fglrx(0): v_active: 900 v_sync: 903 v_sync_end 909 v_blanking: 934 v_border: 0
(II) fglrx(0): Serial No: 5053D0010001(II) fglrx(0): Ranges: V min: 56 V max: 75 Hz, H min: 31 H max: 81 kHz, PixClock max 140 MHz
(II) fglrx(0): Monitor name: L9VB4 (II) fglrx(0): EDID (in hex): (II) fglrx(0): 00ffffffffffff005e74880301010101 (II) fglrx(0): 1410010380291a782ac905a3574b9c25 (II) fglrx(0): 125054a54b0081c08140714081809500 (II) fglrx(0): 0101010101019a29a0d0518422305098 (II) fglrx(0): 36009a001100001c000000ff00353035 (II) fglrx(0): 3344303031303030310a000000fd0038 (II) fglrx(0): 4b1f510e000a202020202020000000fc (II) fglrx(0): 004c395642340a2020202020202000a5 (II) fglrx(0): End of Display1 EDID data -------------------- (WW) fglrx(0): Only one display is connnected,so single mode is enabled (EE) fglrx(0): PreInitDAL failed Regards Georgi