Re: new Etch install fails to boot
On Sun, Jul 29, 2007 at 11:00:30PM -0400:
> [I wrote that my fresh Etch install calls grub and then stops.]
On Wed, 1 Aug 2007 09:21:49 +0300, Andrei Popescu replied:
> IIRC your /boot partition was pretty big. Would it be very complicated
> to make it something like a few hundred megs (less then 512) ?
As shown during partitioning, it was <100 MB, i.e.
IDE5 master (hde) - 41.2 GB IC35L040AVER07-0
#1 primary 98.7 MB B f ext3 /boot
Since each cylinder is 8225280 bytes, this is 12 cylinders.
Reply to: